Local Installation If your NAS supports HDMI output, you can connect it to an HDMI display and follow on-screen instructions to install the firmware. It was frustrating that the bad drive was not being reported.Īfter the system had successfully installed, I clicked Go to NAS Management on the "Congratulations" screen. If your NAS is not connected to the internet, you can use Qfinder Pro to find your NAS over LAN for installing firmware. I then replaced the 4TB HDD with a 2TB Seagate FireCuda drive, and I was able to successfully install and configure the device. The problem comes when I connect both devices directly using the 10Gbps connection using an RJ45 cable. I can connect to the internet in both devices. Qfinder Pro has no issues finding the qnap. As the device does not have a video port, I couldn't see any error messages, and there wasn't a way to see the error logs. I have my qnap (tvs-672xt) and PC connected to my switch (using the 1Gbps connections). Now compare the MAC address of your QNAP NAS with the ones in. Each time it did this, it took about five minutes to reboot. If you go on the WebUI to the Basic - DHCP Client Devices you will see the connected devices. I tried various configurations, but it kept bringing me back to the initial configuration screen after it said that everything was installed. Once my system had rebooted, I found myself stuck in an installation loop when it brought me back to the initial configuration screen and walked me through the configuration process again. It formatted the drive and initialized the system, a process which took about five minutes to complete (it had a countdown timer while the process was taking place) and involved a reboot. I was asked to give the device a name and password, set the time, and select which file services to enable. Default username: admin Default password: The NAS MAC address without any punctuation and all letters capitalized. Launch Qfinder Pro and refresh the list to see any QNAP NAS boxes on the local network The above worked for the following configuration: - Operating system version: MS Windows 10 圆4 patch 1607 - QNAP server model and firmware version: TS-409 with 3.3.3 (1003T) - Qfinder Pro version: 6. It took less than a minute to download the firmware, and then about five minutes to install it and reboot the system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |